In addition to discretion and comprehensive protection, one advantage of permanently installing radar detectors is better integration into the vehicle. The radar detectors in the vehicle are connected and integrated into the operating concept, particularly with regard to the field of vision and operation. If the display of the permanently installed radar detector is located at an unsuitable place, this makes visibility and operation more difficult for the driver, and the reaction time is unnecessarily restricted. Additional, invisible components of the radar detector must also be installed. Basically, a radar receiving antenna is to be installed hidden in the front of the vehicle, which is to be connected to the main unit inside the vehicle with cables so that it is protected from the weather.
Disassembly of the bumper is usually inevitable during the installation process. The cables are then routed to the inside of the engine compartment. A GPS antenna is also connected to the system. A suitable position can also be found here so that the signal is received in a stable manner. The GPS antenna of the vehicle navigation system cannot be used for this. Finally, a loudspeaker and, above all, the display or control unit must be installed in the vehicle. Various locations inside the vehicle can be considered for this. Conceivable is the ashtray, center console, positions left or right next to the steering wheel, it can also be installed in the glove compartment, provided that the driver just wants an audible warning signal.
It is also important to have quick access to the integrated radar detector USB interface in order to be able to update the complete radar laser warning system quickly and easily with new software and the speed camera database from the manufacturers. Of course, all components are hidden behind covers, which often means complete disassembly e.g. the center console cover is required. Finally, a self-sufficient connection to the ignition voltage is established, data bus cables are not used, so that there are no error messages. In rare cases, however, a fault in the fault memory is set in modern vehicles, as may be disconnected during installation, the battery in the vehicle. If necessary, this would have to be deleted. At the customer's request, we can also install manual on / off switches for the system in the cockpit.
If you buy a new car after a while or change a leasing vehicle, you can easily remove your fixed radar detector fixed installation system from us and have it reinstalled in the new vehicle. The time required to remove the radar detector is around 70% compared to the installation, because the search for on-board voltage source and cable channels is eliminated.
Only permanently installed laser jammers offer effective protection against laser measurements. These can already be integrated in complete radar warning systems or can be purchased and operated as a stand-alone device. They always consist of separate laser sensors, which if necessary, in addition to a radar antenna mandatory in the front of the vehicle with free view forward in the vicinity of the plate (for example, in the grill) must be installed. Whether it is optically via LEDs or a display or just an acoustic warning in the cockpit depends on the device and customer requirements. Additional, invisible components must always be installed with the laser jammer, e.g. the CPU unit. Basically, two or more laser-receiving sensors and laser jammer lenses in the front of the vehicle are to be hidden with free view to the front to be connected to the main unit inside the vehicle weatherproof with cables.
Disassembly of the bumper is usually inevitable for the installation of laser jammers. The cables are then routed to the inside of the engine compartment. It is also important to have quick access to the integrated laser jammer USB interface in order to be able to update the laser jammer quickly and easily with new software.
For the known eso interferers against light barriers and sensor measurements (es 3.0), the same statements regarding the installation apply as for the installation of laser interferers. The installation takes place at the license plate holder. If after a while you buy a new car or change the leasing vehicle, you can easily remove your permanently installed laser jammer from us and have it installed again in the new vehicle. The time required for the removal of the laser jammer is about 70% compared to the installation, because among other things the search for on-board voltage source and cable channels is no longer necessary.